Welcome, Guest. Please login or register.

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - hb2000

Pages: [1]
1
General Questions / Re: DNSSEC Problem?
« on: September 18, 2019, 05:06:12 PM »
I downloaded version 178 for i386 - the IMG file updated but on reboot it only gets about halfway on the restart before it gives an error and reboots.  I tried the ISO to install from scratch and it does the same.

2
General Questions / Re: DNSSEC Problem?
« on: September 18, 2019, 03:22:59 AM »
I forgot to add I have tried DNSSEC with both Cloudflare (1.1.1.1) and Quad9 (9.9.9.9) with the same results.

3
General Questions / DNSSEC Problem?
« on: September 18, 2019, 03:20:04 AM »
I am using version 2.11.1b175.  Whenever I turn DNSSEC on, DNS stops working for the computers on the LAN.  As soon as I turn if off, everything starts working again.  Any thoughts or suggestions?  Thanks...

4
General Questions / Re: QOS in 2.11
« on: October 02, 2018, 01:57:24 AM »
Could not get it to work with any browsers, then I remembered I switched from http to https GUI connection, switched back to http, rebooted, and now it's working.

5
General Questions / Re: QOS in 2.11
« on: September 30, 2018, 06:41:53 PM »
Thanks, let me know when it is resolved and I'll retest.  Maybe this should be another topic (?) but my CPU and Traffic graphs do not display anything, would you check that also?  Thanks.

6
General Questions / QOS in 2.11
« on: September 23, 2018, 06:23:28 PM »
The last couple times I tried t1n1wall 2.11 I was unable to get DNS to work.  I saw you had made some changes so I tried it again, but the same problem.  I can ping by ip address but not by name.  I am using the same settings which worked with smallwall.  I checked all the settings but found nothing wrong.  I tried turning off QOS and I was surprised when everything started working.  I tested several times - turn it on and DNS quits workings, turn it off and everything okay.  I used the Magic Shaper Wizard (same as I did in smallwall) to generate the rules, then rebooted the firewall, but it doesn't work with QOS turned on.  Thanks for looking into this.

Pages: [1]